Author: Jonathan Swain (aka "PurdueGuy")
Relevant Models
1991-1995 SL
1991-1995 SL1
1991-1995 SL2
1993-1995 SW1
1993-1995 SW2
Tools
- Small prying device
Removal
Step 1
Remove padded seat end trim.
Step 2
Remove the 2 retainer pins at the top of the trim by the seatback. These are two-piece retainers. Remove the top part of the pin first, then the lower. The top part of the clip looks like a philips screw, but it is not – it will just spin & spin. A prying tool like the one shown below is very helpful, though a small flathead screwdriver could work, too.
Get the prying tool in between the two parts of the head of the retainer, as shown below. 2nd picture shows the inner pin removed.
Step 3
Unclip trim carefully. You will likely break off some clips, unfortunately. To minimize this, use a small prying tool and pry the trim outward as near to the clips as possible. Sadly, some clips will likely still break.
Good clip
Broken clip
Broken clip left in the car
Installation
Installation is the reverse of removal.